Students will be introduced to the techniques of fabrication of a printed circuit board. This includes the design of a printed circuit artwork pattern, the process of layout of an artwork positive on acetate, the making of a negative film of the positive artwork using a photographic process, and the fabrication of the printed circuit board from a copper clad board using photo-resist developing, and an etching process. Each student actually will go through these steps and build a small electronic circuit. One class hour, two laboratory hours.
Prerequisite: A general knowledge of electricity and electronics.
Course Offered Fall and Spring
Use links below to see if this course is offered:
Fall Semester 2015
Spring Semester 2015
Summer Session 2015
Building 8, Room 626
M-F 8:00 a.m. - 4:00 p.m.